▲Uniden Data 2000 Wireless CDPD PC Card
|
|
AT Command Syntax | Description of Command |
|
|
AT SWVER? or ATI1 | Read the software code version |
| downloaded in the Modem from the |
| System Table. |
| Data encrypted version: |
| (Version #) (Date Time) |
| Non encrypted version: No Encrypt |
| Version #)(Date Time) |
| Response: |
| (Date Time) |
| No Encrypt (Version #) (Date Time) |
|
|
AT VERBOSE? | Read 1 for verbose or 0 for terse modes |
| from the System Table. |
| Response: Verbose 0 or Verbose 1 |
| Verbose 0 means terse mode is on, |
| Verbose 1 means verbose mode is on. |
AT CLRAUTH NEI n | Clear Authentication parameters for NEI #n. |
| WARNING: Check with your service |
| provider before taking this step. |
| Response: OK |
AT CMPR <1><0> | Set TCP/IP Header Compression Mode. |
| (On/Off) |
| Response: OK |
|
|
AT FC <1><0> | Set flow control mode (On/Off). |
| (When hardware flow control is enabled, |
| the Modem generates CTS when it is able to |
| accept characters, otherwise it will |
| CTS. The Modem inhibits output to the |
| serial line when the host |
| otherwise it will permit output.) |
| Response: OK |
|
|
Uniden Data 2000 Installation and Operation Manual |