3. Drill the necessary holes and secure the mounting bracket in place using the screws
provided.
4. Mount the radio to the bracket only afterthe wiring has been connected to the rear
panel.
If you are not experienced in connecting accessories to the vehicle fuse box, please
see your automotive dealer for advice on proper installation.
1. Check the vehicle battery connections to determine which battery terminal (positive or
negative) is grounded to the engine block or chassis. Most of today’svehicles use a
negative ground. If your vehicle has a negative ground, follow Steps2 and 3. Otherwise,
skip to the note following Step3.
2. Connect the RED wire of the DC power cord to the accessory contactin your vehicle’s
+12V DC fuse box.
3. Connect the BLACK wire of the DC power cord to the negative side of the vehicle
(usually the chassis).
In vehicles with a positive ground, the RED wire connectsto the chassis and the
BLACK wire connectsto the accessory contact in the fuse box.
4. Insert the DC plug into the DC 12V jack on the back of the scanner.
Connecting the Power Cord
Note:
Installationfor everyday use:
Note: