9. Use the keypadto enter a new Offset Channel, then press E.
•Youcan only input within a range of 380-759.
• If the system is not tracking properly,you may need to
try a new Base Frequency or OffsetChannel, or you
may be missing frequencies from the system.
•You can set up to three Base, Spacing and Offsets for Motorola VHF/UHF trunked
systems.
OnType II trunking systems there is a method by which specialized types of communications
utilize unique talkgroupnumbers. An emergency call will occur on a unique talkgroup from its
primary assignment, for example. Because the UBCT8 defaultsto Status-Bit ON mode, you
never need to worry about missing these transmissions. If you have programmed talkgroup
33264 into Scan List memory,for example, and there is an emergency call within the group,
you will hear it on 33264.
The only time you may wish to turn StatusBits OFF is if you're trying to figure out the proper
Fleet Map of aType I trunking system.
1. Press and hold for 1.5 seconds and select the bank you want to change.
2. Use the or key to select (MotorolaTYPE2 800MHz) , (MotorolaType2
VHF) or (MotorolaType2 UHF), then press .
3. Use the or key to select ,then press .
4. Use the or key to select or , then press .The scanner returns to
StatusBit list item.
When this function is activated, trunking is performed using Control Channel dataonly.
Voicechannel (also known as "DATA channel") frequencies do not have to be programmed
into memory.This feature only applies to Motorola 800 MHz systems.
1. Press and holdTRUNK for 1.5 seconds and select the bank you want to change.
2. Use the or key to select (MotorolaType2 800MHz) or (Motorola Type1
800 MHz), then press .
3. Use the or key to select , then press .
4. Use the or key to select a plan from 2 frequency plans,
then press .The scanner returns to Control Channel Only
list item.
Youmust choose a plan before you begin to Control Channel Trunk (Only when 800
MHz system is selected).
When you deselect Control Channel only mode, appearson the display.
Read the descriptions of the Plan 1~2 for detailson which may apply for you.
Note:
TRUNK
E
E
E
E
E
E
Note:
Togglingthe Status BitControl Channel Only Mode