
Troubleshooting
If your UBCT8 is not performing properly, try the following steps.
Problem |
| Suggestion |
Scanner won't work. | 1. Check the connections at both ends of the AC Adapter. | |
| 2. | Turn ON the wall switch of your room. You could be using an |
| 3. | outlet controlled by the wall switch. |
| Move the AC Adapter to another wall outlet. | |
|
| |
Improper reception. | 1. Check the antenna connection. | |
| 2. | Move the scanner. |
| 3. | You may be in a remote area which could require an optional |
|
| |
|
| electronics store. |
Scan won't stop. | 1. Adjust squelch threshold - refer to page 14, "Setting the | |
| 2. | Squelch". |
| Check the antenna connection. | |
| 3. | Check to see if many of the channels are Locked Out. |
|
| If so, the scanner has less chance of finding an active |
| 4. | channel. |
| Review each channel's frequency to see if it is still stored in | |
| 5. | Memory and is correct. |
| It's possible that none of the programmed frequencies are | |
|
| currently active. |
|
| |
Scan won't start. | 1. Press SCAN key again. | |
| 2. Adjust the SQL control. | |
| 3. | Check to see if all channels are Locked Out. |