Please see page42 for more information.
1. Enter theArea Code.
2. Enter the Home Repeater number.
3. Enter the ID you want to store
4. Press .
When you have properly programmed all the frequencies for a trunked system, you can
monitor the system in several differentways. You will find that Search, Hold, Lockout, Scan
and Delay are all similar to conventional scanning.
letsyou receive those talkgroups that you store in Scan Lists.
letsyou selectively listen to a talkgroup in your Scan Lists.
letsyou hear all system talkgroup activity. This is the best way to get
started.
works with Search mode to let you quickly freeze reception on an
interesting transmission. Or you can manually specify a talkgroupwith
in .
works with Search and Scan to exclude talkgroupsthat you don't want
to hear.
works with each talkgroupto be delayed when the communication ends.
When receiving EDACS systems, remember that Uniden'sAFS talkgroups give you
powerful flexibility.In a few key presses, you can specify a single talkgroup, a fleet, or an
entire agency in all the above modes. Read the section "EDACS Reception" to
understandhow this works.
If the scanner is not in theTrunking mode, you can enter the Trunk mode by
pressing . Pressing in the Trunking mode will move to the Private
Scan Hold mode.
1. When in theTrunking mode, press tobegin scanning the lists you have
programmed.
If you haven't programmed any IDs, the scanner cannot stop
on an active conversation.
2. Toremove a Scan List from active scanning, press the
number of the Scan List on your keypad.
The Scan List indicator turns Off,and the IDs in that list are not scanned.
E
ID SCAN
ID SCAN HOLD
ID SEARCH
ID SEARCH HOLD
DIRECT
ENTRY ID HOLD
ID LOCKOUT
ID DELAY
Hint:
TRUNK TRUNK
SCAN

Note: 0 EToclear a stored ID while entering an ID, press and successively,and

startover.

Receiving Trunked Systems

ID Scan Mode

!
!
!
!
!
!