Setting the Delay Mode for Trunking Mode
A default delay of 2 seconds is automatically set for each talkgroup for ID Scan mode and ID Search mode. To set the delay feature on or off, press DELAY while trunking, “DLY” will appear or disappear depending on your setting.
Trunking Frequency Confirmation
You can check the frequency while a talkgroup ID is active.
Press the 
key ,and the active frequency on which the talk group is transmitting will flash on the display. Or press and hold the 
key for 2 seconds, the ID and the frequency alternately appears on the display. To cancel this mode, press the 
key again.
Hint: This feature is applied to ID Scan mode and ID Search mode.
Setting Priority in Trunking Mode
You can set priority in your Scan lists, just as you do in your conventional ones. Default setting for the Priority ID is the first location in each Scan List. You can set the priority by pressing and holding PRI for 2 seconds in ID Scan Hold mode. After you’ve set up your Scan List, press PRI to activate it.
It’s very similar to conventional priority although there is no "interrupt" during the transmissions. Priorities are checked in between transmissions.
With Priority ON, you can hold on an ID in your Scan List, such as Scan List 3, memory location 7, and the scanner will check all the priorities in all the active Scan Lists in between any transmissions on the ID on which you’re holding. The lowest numbered priority will be checked first. For example, the Priority ID in List 1 will be checked before the Priority in List 2, etc.
Note: •This function does not work in LTR tracking.
• Priority Scan does not operate when Priority IDs are locked out.
Moving between Scan List Memories
There are a number of ways to step and move through your Scan List memories:
1.Press HOLD/RESUME in the ID Scan mode and use the 
or 
key to move to up or down.
2.Or, press HOLD/RESUME in the ID Scan mode, next press
