PL1(plan1):If the last three digits of ALL the frequencies in use end in one of the following

three digits(125, 375, 625, or 875), use PL1(plan1).

PL2 (plan 2):
Note:
TRUNK
E
E
E
Note:
If the last three digitsof ALL the frequencies in use end in one of the
following three digits(000, 250, 500, or 750) use Plan 2.
Of course you will know the Control Channel frequency itselfso that will help you determine
the proper plan. If you try one plan and you receive errors (such as the scanner jumping to
channels that are obviously not partof the system), you should try an alternate Plan.
•You can assign a Fleet Map to TYPE 1 or Hybrid systems scanned in Control
Channel Only mode by going into theTrunk Programming mode. You can also pro-
gram IDs, set a delay,and all the other parameters for systems scanned in this
mode.You can then either search the system to find new IDs or you can program
IDs into memory and then scan them.
•The Control Channel Only feature is an extremely powerful tool. You can use it to
determine if systems you are familiar with may have added new frequencies or you
can use it to discover new systems by simply finding active control channels (using
Search) and then programming them for Control Channel operation only.
Remember that this feature only applies to Motorola 800 systems, that you do have
to set the proper system type (800 MHz ofType 1 or Type 2) and you do have to
program the Control Channel frequency into memory and identify the frequency as
trunked in theTrunk Programming mode.
When this function is disabled, the radio looks for squelch before returning to the Control
Channel instead of waiting for the DisconnectTone. Only in rare instances will you need to
adjust the default settings.The condition to return to Control Channels depends on whether
the signal is present or not.
1. Press and hold for 1.5 seconds and select the bank you want to change.
2. Use the or key to select (MotorolaTYPE2 800MHz), (MotorolaType2
VHF) or (MotorolaType2 UHF), then press .
3. Use the or key to select , then press .
4. Use the or key to select or , then press .
Set the SQLcontrol so that you hear a hissing, and the scanner will remain on the
voice channel (even when a disconnect tone is transmitted or there is no signal at
all).
Disconnect ToneDetect Option (End Code)