ID LockoutReview ID LockoutRestoring Locked-out IDs
Like conventional scanning, it’spossible to lockout unwanted traffic. This is particularly
importantin trunked systems because in many areas, water meters, door alarms, traffic
signals, and other mechanical devices are assigned IDs just like other users.Also some
departmentsscramble or encrust their communications, and you may want to lock out these
unintelligible broadcasts.
ToLockout an ID, press on the ID you want to lockout.
The ID is locked out.You can Lockout up to 100 IDs.
If you Lockout an ID in Search mode, it is also locked out in Scan List mode.
Conversely,if you Lockout an ID while in Scan List mode, it is locked out in Search
mode. For information about Scan Listssee page 31.
is a powerful form of ID Lockout that can be used only withAFS and
EDACS systems.This feature lets you lockout entire Agencies or Fleets, not just individual
talkgroups.Using EDACS Blockout you can, for example, prevent Search from stopping on
any of hundreds of talkgroupsin the Utilities agency. You can do this with just a few key
presses.To use this mode just enter the Agency-part, or the Agency-Fleet part, of the
talkgroupcode and press .For example, to Blockout Agency 4 in TrunkSearch, press
, , , (decimal key), and then . For other ways to use partial AFS
entry,be sure to read the section "EDACS Reception".
Youcan check all IDs already locked out.
1. Press and hold for 1.5 seconds in theTrunking mode.
2. Select the bank you want to review by using the keypad,and then the trunked system
selected appears on the display.Then press .
3. Select by using the or key ,and then press .
4. Youcan see the locked out IDs by using the or key.
Press and hold for2 seconds to check all locked out IDs when in the Trunking
mode.
Whilein locked out review mode, select the locked out ID you want to restore and press
.
Torestore all locked out IDs in a bank once:
Whilein locked out review mode, press and hold for 3 seconds.All locked out IDs in
a bank are restored.
L/O
Note:
EDACS BLOCKOUT
L/O
HOLD/RESUME 0 4 L/O
TRUNK
E
E
Hint: L/O
Torestore a single ID, follow these steps:
L/O
The ID is restored and “L/O” disappears.
L/O
An Error message ("Full") is
displayed when you try to register the 101st lockout.