Wire Checkout:
With all initiating devices and notification appliances installed and with the EOLR’s in place, check the wires with an ohmmeter. Meter readings outside of the following will prevent normal operation.
From any wire to ground – less than 100K ohms.
Across the 2 wires on each Initiating zone – between 1.8K ohms and 5.4K ohms. Across the 2 wires on each notification circuit – between 1.8K ohms and 23.9K ohms.
Mounting Instructions:
1)The unit should be mounted in a convenient location, approximately 5 ft. from the floor where it will be accessible for testing and servicing.
Removal of this false front exposes electrical components at potentially hazardous voltages and should be performed by qualified personnel only.
2)The main circuit board module should be removed before attempting to mount the cabinet. Disconnect the AC power from TB201. To remove the module, remove the two screws holding the chassis to the cabinet. Lift the module upwards, approximately 1/2", in order to clear the
3)Install all required conduits, external wiring and devices and make all connections that are external to the panel. Replace
the module. With the AC power still turned off at the circuit breaker panel, connect the AC hot, neutral and ground wires to the terminal block TB201 as shown on the connection drawing. (See connection drawings on page 54)
4)Connect all the other wiring to the terminals as shown in the connection drawings. Turn the AC power on and connect the standby batteries with the cable provided, polarity must be observed.
5)Replace false front panel and secure with mounting screws.
6)The operation of the complete system should be verified as outlined in the test procedure section.
VFR-400 False Front Removal/Assembly Drawing
DWG#
50
