Vivotek FD8362, 62E manual Set up the Network Camera through Power over Ethernet PoE

VIVOTEK

Internet connection with static IP

Choose this connection type if you are required to use a static IP for the Network Camera� Please refer to LAN configuration on page 53 for details.

Internet connection via PPPoE (Point-to-Point over Ethernet)

Choose this connection type if you are connected to the Internet via a DSL Line� Please refer to PPPoE on page 49 for details�

Set up the Network Camera through Power over Ethernet (PoE)

When using a PoE-enabled switch

The Network Camera is PoE-compliant, allowing transmission of power and data via a single Ethernet cable� Follow the below illustration to connect the Network Camera to a PoE-enabled switch via Ethernet cable�

Power + Data Transmission

POWER	COLLISION	1
			2	3	4	5

When using a non-PoE switch

LINK RECEIVE PARTITION

PoE Switch

If your switch/router does not support PoE, use a PoE power injector (optional) to connect between the Network Camera and a non-PoE switch�

PoE Power Injector

(optional)

Non-PoE Switch

POWER	COLLISION	1
			2	3	4	5

LINK RECEIVE PARTITION

14 - User's Manual