VIVOTEK

Hardware Installation

Removing Dome Cover

First, use the included T20 hex key wrench to loosen the four screws and detach the dome cover from the camera base� Follow the steps below to install the camera either to a ceiling or a

wall�

IMPORTANT! Dome cover should be removed because if it should fall during the instal- lation process, physical injury could occur to your co-workers�

Top View

Dome Cover

 

Dome Cover Retainer

Cabling Assembly

Connect power lines and if you have external devices such as sensors and alarms, make the connection from the general I/O terminal block�

Top View

Power and IO cables pass through a waterproof connector� The Ethernet cable should be routed through a rubber seal plug� All cables are user- supplied�

For Ethernet Cable

For Power & IO Cables

User's Manual - 9

Page 9
Image 9
Vivotek 62E, FD8362 manual Hardware Installation, Removing Dome Cover