VIVOTEK
Install the Wall-mount Bracket
1.The camera weighs 3.66kg. Select a rigid mounting location to prevent vibration to the camera. Attach the alignment sticker to the wall.
2.Drill 4 pilot holes (10mm in diameter and 4cm deep) into the wall, and then hammer in threaded anchors. Note that you should hammer the anchors with hex nuts on them so that the threaded poles will not be deformed! If preferred, drill another hole for routing cables.
3.Secure the wall mount bracket to wall using 4 sets of captive washers and nuts.
2 | 3 |
1
NOTE:
1.IO wires are
2.Avoid touching the circuit boards to prevent damage by electro static discharge.
3.Use CAT5e, CAT6 cables only.
10 - User's Manual
