Vivotek SD8364E, M user manual Connecting Power and I/O Wires

VIVOTEK

2. Connecting Power and I/O Wires

If you need to connect I/O wires and 24V power, disassemble the top section of the camera. It is highly recommended to complete the following before you can mount the speed dome camera at the installation

site:

Skip this section and move to Section 3-3 if you connect the Ethernet cable only.

1-3Connect with the mount bracket

1-1	Cabling through the dome cap and waterproof
	connectors

Plan the wire length and complete cabling to the 1-2Interface Section

2-1. Cabling through the Waterproof Connectors

Components of the Waterproof Connector

Screw Nut (A)

Seal (B)

Seals (C)

Housing (D)

Sealing Nut (E)

•Wire range: 13~16AWG (1.2~1.8mm)

•A socket wrench for the M20 hex nut is required.

14 - User's Manual