VIVOTEK
Interface Section
Ethernet 10/100 RJ45 Plug General I/O Terminal Block
Spring Contacts for Dehumidifier
| Ethernet |
AC24V | DI GND |
AC24V | DI4 |
Reserved | DI3 |
MIC IN | DI2 |
Line OUT | DI1 |
GND | DO2 |
RS485- | DO1 |
RS485+ | DO+(12V) |
Status LED
Item | LED status | Description |
1 | Steady red | Power on and system booting |
| Red LED off | Power off |
2 | Steady red & Green blinking every 1 sec. | Network normal (heartbeat) |
| Steady red & Green LED off | Network failed |
3Red blinking every 0.15 sec. & Green blinking Upgrading firmware every 1 sec.
4Red blinking every 0.15 sec. & Green blinking Restoring default every 0.15 sec.
Hardware Reset
The reset button is used to reset the system or to restore the factory default settings. Sometimes resetting the system can return the camera to normal operation. If the system problems remain after reset, restore the factory settings and install again.
Reset: Press and release the recessed reset button with a paper clip or thin object. Wait for the Network Camera to reboot.
Restore: Press and hold the recessed reset button for a while to restore. Note that all settings will be restored to factory default.
SD/SDHC/SDXC Card Capacity
This network camera is compliant with SD/SDHC/SDXC 32GB, 64GB, and other preceding standard SD cards.
User's Manual - 7
