Vixel 335 manual Number. You can also change the port policies

Vixel Model 335 Installation & Configuration Guide			CHAPTER 3 Management
	Command	Description
	Ports	Displays all information concerning a specific port. When a port number
		(e.g., 2) is entered, the default port number (1) is changed to the new port
		number. You can also change the port policies.
		To view port information, type 7 at the prompt. To see additional
		information for a port, enter the desired port number.
	Zone	Displays information for the default switch's zone (e.g., 1, 2, etc.),
		including general and port-specific information. A menu selection is
		available for each zone.
		To view zone information, type 8 at the prompt.
		When the user chooses to view a zone, all information for that zone is
		displayed along with a port menu listing the ports in that zone.
	Sweep	Displays ordered sets and error detectors for each port on the switch.
		To perform a switch sweep, type 9 at the prompt.
	Diagnostics	Displays diagnostic registers for the default port including the detector,
		match, control, capture, and tx registers.
		Note: These settings should not be modified unless directed to do so by
		Vixel Customer Service.
		To run diagnostics, type 10 at the prompt.
	Reset counters	Resets all or specific counters to zero.
		Options:
		6–reset all port counters in switch
		7–reset all RX frame counters in switch
		8–reset all conn attempt counters in switch
		9–reset all conn stall counters in switch
		10–reset all CRC error counters in switch
		11–reset all bad OS error counters in switch
		To reset counters, type 11 at the prompt. Type the number for the desired
		option.

48