Vixel Model 335 Installation & Configuration Guide | CHAPTER 3 Management |
|
|
Displaying Ports
The Show Port command displays all information concerning a specific port and allows you to change the port policies.
To configure the currently selected port, type po at the prompt.To activate the show port command for a specific port, type po x (where x is the port number) at the prompt.
port 1 | (switch ID=28000070) | ||
| module | : none | |
| state | : bypassed | |
| zone | : | 1 |
| PLL | : | nolock |
| transceiver LED | : | off |
| fault LED | : | off |
| cascade state | : | none |
| connect type | : | none |
| insert count | : | 0 |
| clk delta ppm | : | 0 |
| rx frame count | : | 2 |
| connect attempts : | 0 | |
| connects busy | : | 0 |
| CRC errors | : | 2 |
| bad OS errors | : | 0 |
| port util avg | : | 0 |
| port util high | : | 0 |
| port util low | : | 0 |
| port util last | : | 0 |
(1) | Control |
| : auto |
(2) | Beacon |
| : off |
(3) | Transmitter |
| : on |
(4) | Cascade mode |
| : tree |
(5) | LIP on insert |
| : enabled |
(6)Test before insert : disabled
(7)Overlapping zones : 0x004
(8) | Util period avg | : 100 |
(9)Util period stats : 100
(10)Reset counters
49
