ProScaler
HDMI 1.3
ProScaler has a total of 6 HDMI inputs, version 1.3. Five inputs are on the rear panel, and one HDMI inputs is located on the front of the unit, just under the removable Wolf Cinema logo plate. HDMI carries both video and audio signals.
Note: HDMI is compatible with DVI using an HDMI to DVI adapter cable.
DVI connectors do not carry the audio signal stream, as do HDMI interconnections.
HDMI Video/Audio Output
This connector is used to send all video signals to your Wolf Cinema projector.
HDMI Audio Output
This connector is intended to connect to an AV Receiver or Surround Sound Processor. The ProScaler will automatically sent audio via this connector if it is connected to a
Other Rear Panel Connectors
Connect any
GPIO
Not used.
Service
This connector is used for system software upgrades, using a
Reset
This resets the ProScaler, if needed, bringing it back into a predefined operating condition. Reset initially does not change your settings. If Reset is desired but you wish to retain settings, it should be pressed and released quickly
(less than 2 seconds).
The reset button will also restore the factory defaults. If the reset button is pressed and held, the front panel LED will blink for about 5 seconds. When it stops blinking and stays on, the reset button can be released. All factory defaults will have been restored, and any user settings will be erased.
IR - In
This connecter can be used in installations where
AC Input
Power connection for your ProScaler.
7
