30
C. ToErase All the Learned Commands in One Device Mode
Step 1] Press the Source Device Input button and the ENT buttons simultaneously and hold for 3 seconds until the
Device LED turns on. (The LED will stay on for 20 seconds.The next step must be entered during this period).
Step 2] Press the Source Device Input and Pause buttons simultaneously and hold for 5 seconds until the LED blinks
two times.
Step 3] Toexit this feature, press and hold the Source Device Input button and the ENT button simultaneously, once
again. (The LED will blink three times).
3 Programming the remote with Advanced Functions
A. Programming Multi Commands to Macro Buttons
There are nine (7 for R5) Macro buttons (ON, System Off and7 (5 for R5) Device buttons) that are designed to store up
to 20 commands in each button.
Pressing any one of the Macro button will send out the series of commands that are stored in the button. Forexample,
you either turn on or off several devices at a time by storing Power On/Off commands to these buttons.
Step 1] Forprogramming Macro Commands on a Device button, pressthe Source Device Input and the MUTE buttons
simultaneously and hold for 3 seconds until the Device LED turns on.(The LED will stay on for 20 seconds. The
next step must be entered during this period).
For programming Macro Commands on the POWER ON or SYSTEM OFF button,Press the POWER ON or SYSTEM OFF
button and the MUTE buttons simultaneously and hold for 3 seconds until theTV and SAT/CABLE Devices LED turns on.
(The LED will stay on for 20 seconds.The next step must be entered during this period).
Step 2] Press one of the Macro buttons.
Step 3] Press in up to 20buttons you wish to store in the Macro.(The Device LED will blink once for each buttonpressed).
Tip: Pressinga Device button to change device modes is considered as one command.
Step 4] Press the Channel UP button to save the selection. (The LED will blinkthree times to confirm the programming).
Note: Youcan program delays in between commands by pressing the PAUSE button. Each press add half a second to
the delay.
Note: If you add the delay time at the first step of macro commands, the remote will send the macro commandsonce
you pressed the Macro button for 2 seconds. (Press & Hold Function).
Note: Youcannot program the CH + and PAUSE buttons as a macro command.
ProScalerHigh DefinitionVideo Processor User’s Manual