Worth Data RF Laser Recharging the Batteries

Appendix B

Recharging the Batteries

The LZ400-RF Laser has a rechargeable lithium ion battery built-in.

When not in use, the RF Laser should be plugged into the supplied, regulated

Worth Data 5V power adapter (DO NOT USE ANY Supply Except Worth

Data), so that it will always be recharged. The built-in recharger is a smart

charger, so you can't overcharge the battery and ruin it. A full charge takes

about 3 hours.

If you ordered the USB interface, the F10 power supply included with the laser

is used for recharging, since USB does not usually require the power supply to

power the Base Station (see page 6). The serial configuration will require a

second Worth Data 5v power supply if you want to keep the Base Station

powered up at all times. You can get by with one power supply by simply

unplugging the Base Station so you can recharge the RF Laser Reader.

Contents

Main Table Of Contents Introduction Installation Components of RF Laser Readers Scanner Beeps and LEDs (what they mean) USB Installation Installing the R/F Reader with a dedicated serial port Installing the R/F Reader between a computer and terminal R/F Laser Serial Model Pin-outs Configuring the RF Laser Reader for your computer and application Laser Scanning Instructions Using The RF Laser Setup Menu RF Laser Setup Parameters Channel Code 3 of 9 (Code 39) UPC/EAN Code 128 MSI and Plessey Codabar 2 of 5 Code 2 of 5 Data Length Code 93 Terminator characters (This applies to the BASE only) Beep Options Preamble Postamble Characters Set ID Character Link Test Code Reset DIFFICULT CODE SETUP OPTIONS Page RF Base Station Parameters Baud rate Data bits Parity Stop bits Test the RF Laser with your computer TEST LABEL Page Radio Considerations Operating Instructions Operational Details Range Accumulate Mode 4 5 6 1 2 3 0 Clear Buffer Enter Function/Control Key Support Page Troubleshooting All Models Troubleshooting USB Trouble Shooting Windows XP: Win98/ME: Win2000: Serial Troubleshooting Page Appendix A Changing Jumpers and Channels Page Appendix B Recharging the Batteries Appendix C Specifications for Code 39 *C39* Code 39 Advanced Features and Functions Mod 43 Check Character Full ASCII Extension to Code 39 Appendix D Code 93 Specifications Appendix E Codabar Specifications Codabar start/stop transmission Appendix F Code 128 Specifications UCC-128/ EAN-128 Page Appendix G Interleaved 2 of 5 Code Interleaved 2 of 5 Mod 10 check digit calculation Page Appendix H UPC Specifications UPC 2 and 5-character supplemental codes ISBN Specifications The UPC/EAN checksum character Checksum calculation for UPC-A, EAN-13 and EAN-8 UPC-E Checksum Calculation Appendix I MSI/Plessey Specifications Page RF Laser Setup Menu */+/* */-/* *--* */0/* */K/* */1/* */2/* */+/* */-/* Code 3 of 9 UPC/EAN */A/* */B/* 2 of 5 Code 2 of 5 Length */C/* Page Page *%U* Page Page Index 2 8 A B E F H I L S T U V W