Manuals / Brands / Computer Equipment / Printer / Worth Data / Computer Equipment / Printer

Worth Data RF Laser Installing the R/F Reader between a computer and terminal

1 60

Download 60 pages, 1.37 Mb

5

Installing the R/F Reader between a computer and terminal

If you attach the s Base between your computer and a terminal, as shown

below, using Cable Selection F45-1, bar code data will be sent to the computer

as if it had been typed on that terminal. Refer to page 8 for the details of the

pin-outs for each connector on the cable. You will also need to change jumpers

(JP2 on the RF Base) on the board inside the case from the “S” position to the

“Y” position.

This configuration requires the Worth Data F10 5v power supply for powering

the Base Station. Upon power-up, the Base Station LED will flash with 3 more

flashes than the channel setting; i.e. if it is set on Channel 0, it will flash green

three times. If the Channel were set to 7, it would flash green 10 times.

Cables may require modification, depending on the genders and pin-outs of

your serial ports and cables. You may require "gender changers" (available at

most computer stores) for the two 25-pin connectors. Refer to page 6 for the

details of the pin-outs of the dual port serial cable.

Turn to page 7 to configure the reader using the RF Laser Reader Setup

Menu.

Contents

Main Table Of Contents Introduction Installation Components of RF Laser Readers Scanner Beeps and LEDs (what they mean) USB Installation Installing the R/F Reader with a dedicated serial port Installing the R/F Reader between a computer and terminal R/F Laser Serial Model Pin-outs Configuring the RF Laser Reader for your computer and application Laser Scanning Instructions Using The RF Laser Setup Menu RF Laser Setup Parameters Channel Code 3 of 9 (Code 39) UPC/EAN Code 128 MSI and Plessey Codabar 2 of 5 Code 2 of 5 Data Length Code 93 Terminator characters (This applies to the BASE only) Beep Options Preamble Postamble Characters Set ID Character Link Test Code Reset DIFFICULT CODE SETUP OPTIONS Page RF Base Station Parameters Baud rate Data bits Parity Stop bits Test the RF Laser with your computer TEST LABEL Page Radio Considerations Operating Instructions Operational Details Range Accumulate Mode 4 5 6 1 2 3 0 Clear Buffer Enter Function/Control Key Support Page Troubleshooting All Models Troubleshooting USB Trouble Shooting Windows XP: Win98/ME: Win2000: Serial Troubleshooting Page Appendix A Changing Jumpers and Channels Page Appendix B Recharging the Batteries Appendix C Specifications for Code 39 *C39* Code 39 Advanced Features and Functions Mod 43 Check Character Full ASCII Extension to Code 39 Appendix D Code 93 Specifications Appendix E Codabar Specifications Codabar start/stop transmission Appendix F Code 128 Specifications UCC-128/ EAN-128 Page Appendix G Interleaved 2 of 5 Code Interleaved 2 of 5 Mod 10 check digit calculation Page Appendix H UPC Specifications UPC 2 and 5-character supplemental codes ISBN Specifications The UPC/EAN checksum character Checksum calculation for UPC-A, EAN-13 and EAN-8 UPC-E Checksum Calculation Appendix I MSI/Plessey Specifications Page RF Laser Setup Menu */+/* */-/* *--* */0/* */K/* */1/* */2/* */+/* */-/* Code 3 of 9 UPC/EAN */A/* */B/* 2 of 5 Code 2 of 5 Length */C/* Page Page *%U* Page Page Index 2 8 A B E F H I L S T U V W