Telnet Management, Refer to for more information | Xerox KS-801

Use the supplied RS232 cable to make the console connection directly from a PC COM port. The pin assignments of the connection are:

Switch DTE console port		9-pin PC COM port
Pin2	RXD --------------------------------	3
3	TXD --------------------------------	2
4	DTR --------------------------------	6
5	GND --------------------------------	5
6	DSR --------------------------------	4

The console port does not support modem connection.

5.5 Web Management

Use any web browser with JAVA script support like Netscape Communi- cator 4.x or Microsoft Internet Explorer 4.0 or later on any platform. Con- nect to the managed unit using the IP address as URL address.

http://xxx.xxx.xxx.xxx

Refer to Chapter 7 for more information.

5.6 Telnet Management

Use Telnet software to perform the management operation. The most convenient solution is using the built-in Telnet function in a Windows 95/98/ or NT PC. Enter into DOS window and invoke telnet command :

>telnet xxx.xxx.xxx.xxx

to connect to the managed switch. The specified xxx.xxx.xxx.xxx is the IP address of the managed switch. Refer to Chapter 6 for more information.

-26-

Image 26

Xerox KS-801 Telnet Management, Console port does not support modem connection, Refer to for more information

Contents

10/100 Fast Ethernet Managed Switch with Fiber Connectivity Trademarks Table of Contents Console & Telnet Management Web Management Introduction Features Page Specifications Installing the Switch Packing List Panels Install the Switch into a 19-inch Rack Mounting the SwitchesInstall Rack Mount Brackets Desktop Mounting Network Switched Ports Making Network Connections 10/100BASE-TX Fast Ethernet Switched Ports MDI-X and MDI RJ-45 Connectors Auto-negotiation Capable Manual Configuration10/100BASE-TX Fast Ethernet Ports Auto-speed-sensing Straight-through and Crossover UTP Cable Flow ControlUTP Cable Connections Module Connector type Fiber cable Maximum length Fast Ethernet Fiber Slot Fiber Module Top view Fiber Jumper Setting Module Outline Module Installation Duplex Mode SettingSpecifications Switch supports the following trunk configurations Making Trunk ConnectionsPage Monitored Ports When doing sniffer, configureMaking Sniffer Sniffer Port Interpretation LED IndicatorsLED Panels Performing Network Management Management Support Login Port Status Management objects Setting IP Address Console Management Refer to for more information Telnet ManagementConsole port does not support modem connection Snmp Management Support Console & Telnet Management Select 1 from main menu to set IP address Set IP AddressIP Status Select 2 from main menu to view IP status View Port Status Port status definitions are View Port Counters View STP Status Page Restore Default Values Update Firmware Console Sftp Utility Prompts shown on DOS screen are as follows \WINDOWSSFTP Remote Boot System Processing messages shown on console screen are Start Browser Software and Making Connection Set IP Address for the SwitchWeb Management Web Browser Factory default Username Admin Factory default Password Login to the SwitchLogin Page Port Status Port Statistics Administrator Click Basic to view or modify the following settings Basic IP Address settings are IP Address Use scroll bar to view all settings as follows Snmp Entries Snmp settings are Advanced Click Advanced in menu to perform Advanced / Spanning Page Page Value is lower priority. Range 0 Priority is assigned to the switch. The higherMAC address of the switch as a unique identi Fier to the network Blocking The switch enters the Blocking State if a Ports which are enabled can be in one of the followListening Switches send messages to one another Learning The switch enters the Learning State if no Advanced / Trunking Advanced / Sniffer Page Console Port Information Port Controls Security Manager System Manager Click System Manager to perform Tftp Update Firmware Click Apply to start Tftp file transfer operationsPage Remote Boot System