Installing the Switch, Packing List | Xerox KS-801 guide

2. Installing the Switch

The switch is designed to operate in workgroup environments without a complicated configuration procedure. It also features an auto-select 100- 240V, 50/60Hz power supply unit, which works in most countries around the world.

Before connecting the supplied power cord into the switch, check to see that the cord voltage and current rating conform to the standards of the country of operation.

2.1 Packing List

The switch has the following components shipped with it:

•One switch unit

•One AC power cord

•One RS232 console cable

•19-inch rack mount kit

•CD for installation guide, software modules, MIB file and software operation manuals

-9-

Image 9

Xerox KS-801 operation manual Installing the Switch, Packing List

Contents

10/100 Fast Ethernet Managed Switch with Fiber Connectivity Trademarks Table of Contents Web Management Console & Telnet Management Introduction Features Page Specifications Packing List Installing the Switch Panels Install Rack Mount Brackets Mounting the SwitchesInstall the Switch into a 19-inch Rack Desktop Mounting Making Network Connections Network Switched Ports MDI-X and MDI RJ-45 Connectors 10/100BASE-TX Fast Ethernet Switched Ports 10/100BASE-TX Fast Ethernet Ports Manual ConfigurationAuto-negotiation Capable Auto-speed-sensing Flow Control UTP Cable ConnectionsStraight-through and Crossover UTP Cable Fast Ethernet Fiber Slot Module Connector type Fiber cable Maximum length Module Outline Fiber Module Top view Fiber Jumper Setting Duplex Mode Setting SpecificationsModule Installation Making Trunk Connections Switch supports the following trunk configurationsPage Making Sniffer When doing sniffer, configureMonitored Ports Sniffer Port LED Indicators LED PanelsInterpretation Management Support Performing Network Management Management objects Login Port Status Console Management Setting IP Address Telnet Management Console port does not support modem connectionRefer to for more information Support Snmp Management Console & Telnet Management IP Status Set IP AddressSelect 1 from main menu to set IP address Select 2 from main menu to view IP status Port status definitions are View Port Status View Port Counters View STP Status Page Restore Default Values Console Sftp Utility Update Firmware \WINDOWSSFTP Prompts shown on DOS screen are as follows Processing messages shown on console screen are Remote Boot System Web Management Set IP Address for the SwitchStart Browser Software and Making Connection Web Browser Login to the Switch LoginFactory default Username Admin Factory default Password Page Port Status Port Statistics Administrator Basic Click Basic to view or modify the following settings IP Address IP Address settings are Snmp Entries Use scroll bar to view all settings as follows Snmp settings are Click Advanced in menu to perform Advanced Advanced / Spanning Page Page MAC address of the switch as a unique identi Priority is assigned to the switch. The higherValue is lower priority. Range 0 Fier to the network Listening Switches send messages to one another Ports which are enabled can be in one of the followBlocking The switch enters the Blocking State if a Learning The switch enters the Learning State if no Advanced / Trunking Advanced / Sniffer Page Console Port Information Port Controls Security Manager Click System Manager to perform System Manager Click Apply to start Tftp file transfer operations Tftp Update FirmwarePage Remote Boot System