Configuring the MusicCAST network

MusicCAST network configuration

The MusicCAST server and MusicCAST clients are equipped with an Auto Configuration function that makes configuring network settings on both the MusicCAST server and MusicCAST clients a quick and easy process. Alternatively you can set all relevant network parameters manually if you wish.

Preparing to use Auto Configuration Using Auto Configuration

Carry out the Auto Configuration process on the MusicCAST server and each MusicCAST client you wish to use. The Auto Configuration process requires you to carry out operations on both the MusicCAST server and the MusicCAST client.

The default settings of the MusicCAST server when it is shipped from the factory allow the Auto Configuration process to work smoothly when the user MusicCAST server is only connected to other MusicCAST components. If you wish to connect the MusicCAST server to the Internet using a broadband router, or to your home LAN, carry out the procedure described on page 110 to set the MusicCAST server to act as a DHCP client before attempting Auto Configuration.

If you want to use your MusicCAST components on a network shared with other non MusicCAST components when there is no DHCP server present, you should manually configure the following parameters before attempting the Auto Configuration process:

Select an IP address for the MusicCAST server (see page 108). The default setting is 192.168.1.1.

Set the MusicCAST server to act as a DHCP server (see page 110). The MusicCAST server is set to act as a DHCP server by default.

Set a start IP address for the DHCP service provided by the MusicCAST server, ensuring that IP addresses provided by the DHCP service and the IP address of the MusicCAST server are under the same subnet (see page 110). The default start address is 192.168.1.2 .

-You can carry out Auto Configuration from multiple locations if necessary, but you may find it convenient to gather all of your MusicCAST components in one place for this procedure.

Carry out the Auto Configuration process on the MusicCAST server and each MusicCAST client you wish to use. The Auto Configuration process requires you to carry out operations on both the MusicCAST server and the MusicCAST client.

To carry out the Auto Configuration process, follow the procedure described below:

1Use the following procedure to place the MusicCAST server in Auto Configuration mode:

1 Press TOP MENU.

2 Use / to move the cursor to “System Setup” and press

SELECT.

3 Use / to move the cursor to “Network” and press

SELECT.

4 Use / to move the cursor to “Auto Configuration” and press SELECT.

5 When the Auto Configuration prompt screen appears on the on-screen display, press SELECT.

The MusicCAST server switches to Auto Configuration mode, and the Auto Configuration screen appears on the on-screen display. All playback operations on the MusicCAST system stop.

NOTE

The MusicCAST server only allocates IP addresses to

MusicCAST components when acting as a DHCP server.

2 Follow the instructions in the MCX-A10 owner’s manual (in the section on Auto Configuration in the MCX-A10 owner’s manual) to start Auto Configuration on Your MusicCAST Client.

106

Page 106
Image 106
Yamaha mcx-1000 manual MusicCAST network configuration, Configuring the MusicCAST network, 106