Yamaha mcx-1000 manual 107, Configuring the MusicCAST network

Models: mcx-1000

1 148
Download 148 pages 34.5 Kb
Page 107
Image 107

Configuring the MusicCAST network

3If the following screen appears on your MusicCAST client on-screen display, use / on the MusicCAST client remote control or front panel to select the server ID that appears on the top right of the MusicCAST server on-screen display.

6Use / // to move the cursor to “OK” and press SELECT to save the changes you have made and complete the Auto Configuration process.

The MusicCAST server restarts its network hardware. This can take a few minutes.

Select Cancel and press SELECT to exit the Auto Configuration process without making any changes.

NOTE

There is a 10-minute time limit for this operation. If you do not complete this operation within the time limit, the MusicCAST server exits from the Auto Configuration process without making any changes.

The MusicCAST server can only connect to seven MusicCAST clients, and not attempt to connect to does other clients if it already has seven clients registered. To remove unwonted MusicCAST clients, use / // to move the cursor to a client ID, and then move the cursor to “CLR” and press SELECT.

The auto configuration process does not remove previously registered MusicCAST clients. These are displayed in blue.

NOTE

The selection screen only appears if there are other MusicCAST servers in Auto Configuration mode nearby.

4The Client ID of the MusicCAST client you are attempting to configure appears in the MusicCAST server on-screen display.

5Repeat steps 2-4 for other MusicCAST clients as necessary.

Configuring the MusicCAST network

107

Page 107
Image 107
Yamaha mcx-1000 manual 107, Configuring the MusicCAST network