Yamaha DSP5D, PM5D-RH V2 Inserting an internal effect into a channel

PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Operating section 113
14
Effects
10 In the MIX section, press the [MIX MASTER]
key to turn it on (LED lit).
When the [MIX MASTER] key is on, you can use the
controls of the MIX section to control MIX channels
1–24.
11 Press the MIX channel 1 MIX [ON] key to
turn it on. Use the MIX encoder of that MIX
channel to adjust the master send level of
the signal sent to the effect.
12 In the FX RTN channel strip, press the FX
RTN channel 1 [ON] key to turn it on.
13 Use the FX RTN channel 1 fader to adjust the
effect return level.
Hint
The input/output levels of the effect can be viewed in the
meters shown in the EFFECT PARAM screen or EFFECT
ASSIGN screen.
Inserting an internal effect into a channel
You can insert an internal effect into a channel by assigning the input/output of the internal effect to the insert-out/insert-in of
the desired channel. As an example, here’s how to insert an effect into an input channel.
1In the DISPLAY ACCESS section, repeatedly
press the [EFFECT] key to access the EFFECT
PARAM screen.
2To select the effect module you want to use,
click the / buttons at the left and right of
the box in the upper left of the screen.
3In the INPUT area, use the / buttons at
the left and right of the L CH box to select the
insert-out of the channel into which you want
to insert the effect, and press the [ENTER] key.
(If a signal route has already been assigned, a
window will ask you to confirm the assign-
ment change.)
If you are inserting the effect into a stereo channel (or
two paired channels), use the R CH box to assign the
insert-out for the other channel in the same way.
4In the OUTPUT area, use the / buttons at
the left and right of the L CH box to select the
insert-in assigned to the L output of the effect.
If you are inserting the effect into a stereo channel (or
two paired channels), use the R CH box to assign the
insert-in for the other channel in the same way.
5In the DISPLAY ACCESS section, repeatedly
press the INPUT [PATCH] key to access the
INSERT/DIRECT OUT POINT screen.
6Turn on the INSERT ON/OFF button for the
channel into which you inserted the effect.
This enables the effect insertion for the corresponding
channel.
7Use the buttons of the INSERT I/O area to
specify the insert-out/in point.
Hint
For details on the INSERT I/O area, refer to INSERT/DIRECT
OUT POINT screen ( ➥ p.281) in the Reference section.
8Turn on the [ON] key for the channel into
which you inserted the effect, and use the
fader to adjust the input level.
9Access the EFFECT PARAM screen, and drag
the MIX BALANCE knob to adjust the balance
of the effect sound and original sound.
The input/output levels of the effect can be viewed in
the meters shown in the EFFECT PARAM screen or
EFFECT ASSIGN screen.
EFFECT PARAM
OUTPUT area
INPUT area MIX BALANCE knob
The effect module you are using INSERT I/O area INSERT/DIRECT OUT POINT
INSERT ON/OFF button