PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Reference section 309
Information shown
in the display
Function
menu
Global
functions
Output
functions
Input
functions
Appendices
Here you can perform realtime control of surround pan-
ning for the two currently selected input channels.

AChannel selection

Select the two adjacent odd-numbered/even-num-
bered input channels (or ST IN channel L/R) that you
want to control. The names of these channels are dis-
played at the right.

BDIVERGENCE

These controls specify the proportion at which the sig-
nals are sent to each surround bus when the input
channel is positioned in the center. Depending on the
currently selected surround mode, the displayed
parameters will differ as follows.

❏ If Surround Mode = 3-1ch/5.1ch

A knob for controlling the front
divergence is displayed. Use this
knob to specify the proportion (0–
100) at which a signal positioned
in the center will be sent to the
center bus (C) and the left/right
buses (L, R). With a setting of 0
the signal will be sent only to the
left/right buses, and with a setting
of 100 it will be sent only to the center bus. With a set-
ting of 50, the signal will be sent at the same level to the
left/right and center buses.

❏ If Surround Mode = 6.1ch

An F knob for controlling the front divergence and an
R knob for controlling the rear divergence are dis-
played. Use these two knobs to specify the proportion
(0–100) at which a signal positioned in the center will
be sent to the center buses (C, S, Bs) and the left/right
buses (L, R, Ls, Rs).
In 6.1ch mode, a LINK button
that links the front and rear diver-
gence is displayed between the F
knob and R knob. When you turn
the LINK button on, the F knob
value will be copied to the R knob,
and the F knob and R knob values
will be linked.

CLFE (Low Frequency Effect)

This adjusts the output level of the signal sent from the
input channel to the LFE (Low Frequency Effect) bus
for a subwoofer. You can use the ON/OFF button to
switch the signal sent from the input channel to the
LFE bus on/off.
The LFE knob and ON/OFF button are displayed only
when the surround mode is 5.1ch or 6.1ch.

DSurround pan grid

This grid lets you control the surround panning, with
the listening point at the center. The current setting is
indicated by a O symbol.

EPosition buttons

These buttons correspond to each surround bus. When
you click a button, the surround panning will move to
that position.

FSURROUND BUS ON/OFF buttons

These buttons are on/off switches for the signal sent
from the input channel to the corresponding surround
bus.

GSurround pan position

This indicates the coordinate locations of the O sym-
bol in the left/right direction and the front/rear
direction.
SURR PARAM (Surround parameter)
screen
SURR PARAM
1
2
3
4

5 6 7