Yamaha DSP5D, PM5D-RH V2 OUTPUT VIEW function

OUTPUT VIEW function

270 PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Reference section

OUTPUT VIEW function

This screen displays the mix parameters of the currently

selected MIX channel, MATRIX channel, or STEREO A/B

channel. In this screen you can also edit the principal

parameters and access other screens.

AChannel

This is the number of the channel you are editing. If

the corresponding MIX/MATRIX channel is paired (or

if a STEREO A/B channel is selected), a heart symbol is

displayed at the right. You can click this symbol to

enable/disable pairing for the MIX/MATRIX channel.

Note

The screen shown above is for when a paired channel is

selected. If the selected channel is not paired, the parameters

for only one channel are displayed, and pairing-related set-

tings are not displayed.

BEQ

This area shows the post-EQ level, the approximate EQ

response, and the EQ on/off status. You can click the

EQ ON/OFF button to switch EQ on/off in this screen.

If you click the mini-graph, the EQ PARAM screen for

that channel will appear.

CCompressor

This area shows the amount of gain reduction and the

output level of the compressor, a mini-graph showing

the approximate response of the compressor, and the

compressor on/off status. You can click the COMP

ON/OFF button to switch the compressor on/off in

this screen. If you click the mini-graph, the COMP

PARAM screen for that channel will appear.

DInsert in

This area indicates the insert point, the insert on/off

status, and the type and input level of the port that is

patched to insert-in. You can click the INSERT ON/

OFF button to switch insertion on/off in this screen.

If an internal effect is patched, the effect type and

BYPASS button are displayed. If a GEQ module is

patched, the GEQ ON/OFF button and a mini-graph

showing the GEQ response are displayed.

EDELAY

In this area you can view and edit the delay time of the

internal delay and its on/off status.

FTO MATRIX (only for MIX channels and

STEREO A/B channels)

This area shows the send level, send position, and on/

off status of the signals sent from the corresponding

MIX channel or STEREO A/B channel to MATRIX

buses 1–8. You can also edit the send level, send posi-

tion, and on/off status in this screen. Here’s how to do

this.

• To edit the send level of signals sent to the MATRIX

bus

Move the cursor to the desired bar graph in the list,

and turn the [DATA] encoder.

• To edit the send position of signals sent to the

MATRIX bus

Click either the PRE FADER, the POST FADER, or the

POST ON button located below.

Alternatively, you can edit the setting by moving the

cursor to the PRE or POST indication in the list and

pressing the [ENTER] key or turning the [DATA]

encoder.

CH VIEW (Channel view) screen

CH VIEW