Yamaha DSP5D, PM5D-RH V2 HA (Head Amp) screen

SYS/W.CLOCK function

228 PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Reference section

In this screen you can make settings such as phantom

power (+48V), gain, and HPF for each of the internal head

amps (PM5D-RH model and DSP5D only), or for each

channel of an external head amp device that supports

remote control via the dedicated protocol (e.g., Yamaha

AD8HR or AD824).

ADISPLAY MODE

Select one of the following as the type of head amp dis-

played in the screen.

• INTERNAL HA (PM5D-RH/DSP5D)

The internal head amp channels (AD IN 1–48, AD

STIN 1–4) will be displayed.

• EXTERNAL HA 1-4

• EXTERNAL HA 5-8

The channels of an external head amp device (ID num-

ber= 1–4, or ID number= 5–8) connected via the [HA

REMOTE] connector will be displayed.

Hint

Up to eight external devices can be daisy-chained to the

PM5D’s [HA REMOTE] connector. In this case, an ID number

(1–8) is automatically assigned to each device, starting from

the device that is connected directly to the PM5D’s [HA

REMOTE] connector.

BModel name

For each ID number, this indicates the model name of

the external head amp device that is connected. If no

device is connected this will indicate “-----”. However

even in this case, you will be able to make the same set-

tings as when a Yamaha AD8HR is connected.

CSlot/Channel

Here you can view/select the slot and channels to

which the audio output of the external head amp

device is connected.

Note

If an external head amp device is connected to a PM5D slot,

you must specify the appropriate slot/channels manually.

Please note that if you specify an incorrect setting, the input

channel HA indication in screens such as the IN HA screen

may differ from the actual state.

D+48V MASTER

If an AD8HR is connected via the [HA REMOTE] con-

nector, this indicates the master phantom power on/off

status. (Otherwise, this indicates “---”.)

E+48V

Switches phantom power (+48V) on/off for each

channel.

FHPF (High Pass Filter)

Turns the HPF on/off for each channel.

GCutoff frequency

Specifies the HPF cutoff frequency for each channel of

the AD8HR. Move the cursor to the box, and turn the

[DATA] encoder to adjust the cutoff frequency in a

range of 20–600 Hz.

HGAIN

Adjusts the gain for each channel. Move the cursor to

the knob, and turn the [DATA] encoder to adjust the

gain in a range of –62 dB to +10 dB. The current value

is shown in the box below.

Note

The PAD will be switched on or off internally when the gain of

the PM5D-RH internal head amp is adjusted between –14 dB

and –13 dB. Keep in mind that noise may be generated if

there is a difference between the Hot and Cold output imped-

ance of the external device connected to the INPUT

connector/ST IN connector when using phantom power.

IGANG

If this button is on, the gain settings of two adjacent

odd-numbered/even-numbered channels will change

in tandem, maintaining the current offset value.

JLIBRARY

This button displays the HA LIBRARY screen

(➥ p.230).

Note

When an external head amp device is connected for the first

time, the settings on the external head amp device are used. If

you subsequently recall a HA library item, the HA library set-

tings are used.

HA (Head Amp) screen