Yamaha DSP5D, PM5D-RH V2 Function , Global , Output , Input , LCR screen

PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Reference section 267

Information shown

in the display

Function

Global

functions

Output

functions

Input

functions

Appendices

Here you can make settings for LCR mode, which allows

three-channel playback by adding a CENTER channel to

the L/R channels of the STEREO bus. This function can be

used only with MIX channels.

AResponse graph

These graphs indicate the approximate LCR response

for each MIX channel. The graph will change as the

CSR knob (2) is edited.

BCSR (Center Side Ratio)

This knob adjusts the proportional level of the CEN-

TER channel relative to the L/R channels. The range is

0–100%.

If the CSR knob is set to 0%, turning the PAN knob in

the MIX TO STEREO area of the MATRIX/ST ROUT-

ING screen (or the [PAN] encoder in the SELECTED

CHANNEL section) will change the signal levels of the

L/R channels as shown below.

In this case, MIX TO STEREO PAN will operate as a

conventional PAN control, and no signal will be sent to

the CENTER channel.

If CSR is set to 100%, turning the PAN knob ([PAN]

encoder) will change the signal levels of the L/R chan-

nels as shown below.

When the PAN knob ([PAN] encoder) is in the center

position, the signal level of the CENTER channel will

be at maximum, and no signal will be sent to the L/R

channels.

CLCR (LCR mode on/off)

For each MIX channel, this turns LCR mode on/off.

For channels where LCR mode is turned on, the PAN

knob in the MIX TO STEREO area of the MATRIX/ST

ROUTING screen can be used to simultaneously con-

trol the levels of the L/R channels and the CENTER

channel.

If you have selected a MIX channel for which LCR is

on, you can also use the [PAN] encoder in the

SELECTED CHANNEL section of the top panel. In

this case, the peripheral LEDs will change as follows

when you operate the [PAN] encoder.

• When LCR = off

• When LCR = on

Note

In order to use the LCR function, the USE AS CENTER BUS

button must be turned On in the MIXER SETUP screen (SYS/

W.CLOCK function) (

➥

p.222). Be aware that when this but-

ton is on, the CENTER channel signal is not sent to the

STEREO B bus, and will not play back appropriately. (In this

case, the STEREO B bus is sent the same signal as the STE-

REO A bus.)

LCR screen

LCR

CRL

Signal sent to the

R channel

[PAN] encoder

Signal sent to the

L channel

Signal level

CRL

[PAN] encoder

Signal sent to the

R channel

Signal sent to the

C channel

Signal sent to the

L channel

Signal level

RLRL RL