Yamaha DSP5D, PM5D-RH V2 Connecting the DSP5D to your computer via Ethernet

PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Operating section 159

Other functions

Connecting the DSP5D to your computer via Ethernet

You can use the DSP5D Editor program installed in your computer to control the DSP5D’s parameters and to back up and

restore the contents of its memory.

Here we will explain the necessary steps for using an Ethernet cable to connect the DSP5D to your computer.

Note

•The following steps assume that the DSP5D Editor program

and DME-N Network driver have been correctly installed in

your computer. Before you continue, download the program

and driver from the Yamaha website and install them.

http://www.yamahaproaudio.com/

•For details on settings when using the DSP5D by itself, refer

to the DSP5D Editor Owner’s Manual. If you do not know the

network settings, you can initialize the internal memory

(

➥

p.160) to return the settings to the default values listed in

step 3.

1In the DISPLAY ACCESS section, repeatedly

press the [UTILITY] key to access the PREFER-

ENCE 2 screen.

2In the NETWORK area at the lower right of the

screen, click the SET button to access the NET-

WORK window.

AIP ADDRESS

This specifies the number (IP address) that is assigned

in order to distinguish individual devices within the

Internet or LAN (Local Area Network). Set this so that

it does not conflict with other devices on the network.

BGATEWAY ADDRESS

This specifies a number (gateway address) that distin-

guishes devices (gateways) that convert data between

different media or protocols to allow communication

within the network. Set this so that it does not conflict

with the IP address of other devices on the network.

CSUBNET MASK

Within the IP address used in the network, this defines

the bits that are used for the network address that dis-

tinguishes the network.

3Specify the IP address, gateway address, and

subnet mask by clicking the / buttons

located at the left and right of each box.

If you’re connecting the DSP5D and your computer in

a one-to-one connection, we recommend that you use

the following default values.

• IP address

192.168.0.129

• Gateway address

192.168.0.1

• Subnet mask

255.255.255.0

4Click OK to close the NETWORK window.

5Make network settings on your computer.

For the case of the example shown above, set the IP

address in the range 192.168.0.2–127, and set the gate-

way address and subnet mask to the same value as the

DSP5D.

6Use an Ethernet cable to connect the com-

puter and the DSP5D, and start up DSP5D

Editor on your computer.

This will allow communication between your com-

puter and the DSP5D. For specific operating

procedures, refer to the DSP5D Editor Owner’s

Manual.

PREFERENCE 2

SET button