Yamaha RX-V861 owner manual 101 En, XM Satellite Radio, Remote control, page, The remote control

Troubleshooting

■XM Satellite Radio

If an operation takes longer than usual or an error occurs, one of the following messages may appear in the front panel display. In this case, read the cause and follow the corresponding remedies.

Status message	Cause	Remedy	See
			page
CHECK ANTENNA	The XM Mini-Tuner and XM Dock are	Check XM Mini-Tuner and XM Dock connections	53
	not connected to the XM jack of this unit	and orient for the best reception level.
	or do not work properly.
UPDATING	The XM user encryption code is being	Wait until the encryption code is updated.	—
	updated.
NO SIGNAL	The signal is too weak.	Adjust the orientation of the XM Mini-Tuner for the	53
		best reception level.
LOADING	It takes longer than four seconds for audio	Wait until the decoding process has finished.	—
	or text data to be decoded.
OFF AIR	The XM Satellite Radio channel you	Check the channel number again or select another	—
	selected is not currently broadcasting any	XM Satellite Radio channel.
	signals.
<XM> - - -	The Channel Station ID (SID) is no longer
	available.
- - - / - - -	No artist name or song title is available.
<CAT> - - -	No channels are available for the selected	Select another channel category by pressing	55
	category.	4CATEGORY on the front panel (or DA-E/CAT.
		l/ hon the remote control) repeatedly.

■Remote control

Problem	Cause	Remedy	See
			page
The remote control	Wrong distance or angle.	The remote control will function within a maximum	27
does not work or		range of 6 m (20 ft) and no more than 30 degrees off-
function properly.		axis from the front panel.
	Direct sunlight or lighting (from an	Reposition this unit.	—
	inverter type of fluorescent lamp, etc.) is
	striking the remote control sensor of this
	unit.
	The batteries are weak.	Replace all batteries.	—
	The operation mode selector is set	Set the operation mode selector correctly.	—
	incorrectly.	When operating this unit, set it to the KAMP
		position.
		When operating the component selected by the input
		selector button, set it to the KSOURCE position.
		When operating the TV set in the DTV or PHONO
		area, set it to the KTV position.
	The remote control code was not correctly	Set the remote control code correctly using “List of	88
	set.	remote control codes” at the end of this manual.
		Try setting another code of the same manufacturer	88
		using “List of remote control codes” at the end of this
		manual.
	The ID code of the remote control and the	Match the remote control ID of this unit with the	94
	remote control ID of this unit do not	corresponding remote control ID code.
	match.

INFORMATION ADDITIONAL

English

101 En