Yamaha RX-V861 owner manual Recording, 60 En

Recording

Recording adjustments and other operations are performed from the recording components. Refer to the operating instructions for those components.

Caution

The DTS signal is a digital bitstream. Attempting to digitally record the DTS bitstream will result in noise being recorded. Therefore, if you want to use this unit to record sources encoded in DTS, the following considerations and adjustments need to be made. To play DTS-encoded DVDs and CDs (when using a digital audio connection) on your DTS-compatible player, follow its operating instructions to make a setting so that the analog signal will be output from the player.

Notes

•When this unit is set to the standby mode, you cannot record between other components connected to this unit.

•TONE CONTROL (see page 48) and VOLUME settings, the speaker level (see page 74) and the sound field programs (see page 42) do not affect recorded material.

•The source connected to the MULTI CH INPUT jacks of this unit cannot be recorded.

•The XM Satellite Radio signals cannot be output at the AUDIO OUT (REC) jacks.

•Digital signals input at the DIGITAL INPUT jacks are not output at the analog AUDIO OUT (REC) jacks for recording. Likewise, analog signals input at the AUDIO IN jacks are not output at the DIGITAL OUTPUT jack. Therefore, if your source component is connected to provide only digital or analog signals, you can only record digital or analog signals.

•A given input source is not output on the same OUT (REC) channel.

•S-video and composite video signals pass independently through the video circuits of this unit. Therefore, when recording or dubbing video signals input from a video source component that provides only an S-video or a composite video signal, you can only record an S-video or a composite video signal on your VCR.

•The analog audio signals input at the DOCK terminal can be output at the analog AUDIO OUT (REC) jacks for recording.

•Check the copyright laws in your country to record from CDs, radio, etc. Recording of copyrighted material may infringe copyright laws.

y

Do a test recording before you start an actual recording.

If you play back a video source that uses scrambled or encoded signals to prevent it from being dubbed, the picture itself may be disturbed due to those signals.

1Turn on all the connected components.

2Rotate the IINPUT selector (or press one of the input selector buttons (A)) to select

the source component you want to record from.

3Start playback on the selected source component or select a broadcast station.

4Start recording on the recording component.

60 En