Yamaha RX-V861 Connecting the FM and AM antennas, Connecting the power cable, 24 En, Notes

Models: RX-V861

1 129
Download 129 pages 12.39 Kb
Page 28
Image 28
Connecting the FM and AM antennas

Connections

Connecting the FM and AM antennas

Both FM and AM indoor antennas are supplied with this unit. Connect each antenna correctly to the designated terminals. In general, these antennas should provide sufficient signal strength.

y

See page 8 for connection information of the supplied indoor FM antenna and AM loop antenna.

Notes

The AM loop antenna should be placed away from this unit.

The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.

A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, install an outdoor antenna. Consult the nearest authorized Yamaha dealer or service center about outdoor antennas.

Indoor FM

AM loop

antenna

antenna

(supplied)

(supplied)

 

ANTENNA

 

 

 

 

FM

 

GND AM

 

75 UNBAL.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Outdoor AM antenna

Use a 5 to 10 m (16 to 33 ft) vinyl-covered wire extended outdoors from a window.

Ground (GND terminal)

For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.

Connecting the power cable

(U.S.A. model)

To the AC wall outlet

AC OUTLETS

AC OUTLET(S) (SWITCHED)

U.K. and Australia models

..................................... 1 outlet

Korea model

None

Other models

2 outlets

Use these outlet(s) to supply power to any connected components. Connect the power cable of your other components to these outlet(s). Power to these outlet(s) is supplied when the main zone or Zone 2 is turned on. However, power to these outlet(s) is cut off when the main zone and Zone 2 are turned off or when BMASTER ON/OFF on the front panel is pressed and released outward to the OFF position. For information on the maximum power or the total power consumption of the components that can be connected to these outlet(s), see “Specifications” on page 109.

Note

The power to AC OUTLET(S) of this unit is not cut off while this unit is charging connected iPod even when this unit is in the standby mode. When this unit completes charging or the iPod is disconnected, the power is cut off automatically when this unit is in the standby mode.

Memory back-up

The memory back-up circuit prevents the stored data from being lost even if this unit is in the standby mode. However, the stored data will be lost in case the power cable is disconnected from the AC wall outlet or if the power supply is cut off for more than one week.

24 En

Page 28
Image 28
Yamaha RX-V861 Connecting the FM and AM antennas, Connecting the power cable, 24 En, Ac Outlets Switched, Notes