4-13
ENG
CAMSHAFTS
CAUTION:
CAUTION:
NOTE:
CAMSHAFTS ENG
d. Check if the punched marks c on both cam-
shafts are inside the holes of camshaft caps
d. If they are not in the position, repeat the
above steps.
e. Tighten the bolts (camshaft cap) in a criss-
cross pattern from the inside outwards.
The bolts (camshaft caps) must be tight-
ened evenly or damage to the cylinder head,
camshaft caps and camshaft will result.
Bolt (camshaft cap):
12 Nm (1.2 mkg)
f. Remove the safety wire from the timing
chain.
3. Install:
timing chain tensioner
Installation steps:
a. Remove the tensioner cap bolt 1, washer
2 and springs 3.
b. Release the timing chain tensioner one-way
cam 4 and push the tensioner rod 5 all the
way into the timing chain tensioner housing.
c. Install the timing chain tensioner with a gas-
ket 6 onto the cylinder.
Always use a new gasket.
The timing chain tensioner teeth should face
down.
Timing chain tensioner bolt:
10 Nm (1.0 mkg)
d. Install the springs 3, washer 2 and cap bolt
1.
Cap bolt (timing chain tensioner):
20 Nm (2.0 mkg)
4. Check:
Valve timing
Out of alignment Reinstall the camshafts
by referring the above steps.