7-21
ELECTRIC STARTING SYSTEM ELEC
NOTE:
New
5 Nm (0.5 mkg)
NOTE:
5. Measure:
brush length a
Out of specification Replace the brushes
as a set.
Min. brush length
5 mm
6. Measure:
brush spring force
Out of specification Replace the brush
springs as a set.
Brush spring force
7.65 X 10.01 N (0.780 X 1.021 kg)
7. Check:
gear teeth
Damage/wear Replace the gear.
8. Check:
oil seal
Damage/wear Replace the defective
part(-s).
EAS00772
Assembling The Starter Motor
1. Install:
brush holder 1
Align the tab a on the brush holder with the slot
b in the starter motor rear cover.
2. Install:
starter motor yoke 1
O-rings 2
starter motor front cover 3
starter motor rear cover 4
bolts
Align the match marks a on the starter motor
yoke with the match marks b on the front and
rear covers.