Zebra Technologies S-500 manual Removing the Label Backing Material Peel Off Option Required

Getting Started

1

Figure 6 Peel-Off Mode Media Loading

Removing the Label Backing Material (Peel Off Option Required)

When the amount of backing wound on the Backing Rewind Spindle reaches full capacity, the Backing Rewind Spindle Full Sensor activates, the Paper/Ribbon light flashes, and printing pauses.

To remove the backing material, follow these steps (you don’t need to turn the printer Power OFF for this procedure):

1.Unwind about 24" of backing from the Backing Rewind Spindle and cut it off at the spindle.

2.Pull out the Hold Down Hook and slide the backing material off of the Spindle and discard.

3.Feed the new starting edge of the backing through the mechanism and attach it to the Backing Rewind Spindle as described in the loading procedure.

4.While holding the media in position against the Tear-Off/Peel-Off Plate, Open and Close the Printhead without disturbing the media position. The printer is now ready to print more labels.

9