Zebra Technologies SL5000r/T5000r manual Format Convert None*, 150-300 PPI/ZGL Setup Menu

Table 2: ZGL Menu (continued)

Zebra Xilll Series	SL5000r/T5000r with ZGL Emulation
Save Settings -	CONFIG CONTROL Menu,
Permanent* - Saves changes even after	Save Config. - Saves changes to 8 cust. Configs. (same
power is turned off.	as Zebra Permanent).
Temporary - Saves until changed again or	NOTE: Changes to all configs. act same as Zebra
until power is turned off.	Temporary mode unless config. saved as 1 of 8 custom
	Configs.
Cancel - Cancels all changes since entering	Cancel N/A - Printer auto cancels like Zebra if Config
Config mode.	changes are not saved or if another Config is loaded.
	Load Config. - Loads Factory default and 1-8 custom
Load defaults - Loads Factory defaults.	configurations.
	Power-Up Config - Selects Factory or 1 of 8 custom
N/A	Configs. as power-up configuration.
	Delete Config. - Deletes any of up to 8 saved custom
	configurations.
N/A	Print Config. - Prints Factory, Pwr-Up, Current, All, or
	custom Configs. 1-8.
N/A	Protect Configs. - When enabled, prevents saving &
	overwriting any existing saved custom Config.
N/A	Name Config. 1-8- Permits using up to 15 characters to
	name a custom Config.
N/A
Format Convert – (None*, 150-300, 150-	PPI/ZGL SETUP Menu,
600, 200-600, 300-600).	Resolution Mode - Full*, Half
Selects the bitmap scaling factor.
Idle Display (opt)- (Firmware ver, mm/dd/yy	N/A
(24 hr), dd/mm/yy (24 hr), mm/dd/yy (12 hr),
dd/mm/yy (12). Sets LCD display options for
real time clock, if installed.
Set Date (opt)	N/A
mm/dd/yy
dd/mm/yy
Set Time (opt)	N/A
24 hour
12 hour
IP Resolution (opt) -	N/A
Dynamic* - Server selects IP Address.
Permanent - User selects IP Address.
IP Protocols (opt) - (All*, Gleaning only,	N/A
RARP, BOOTP, DHCP).
If Dynamic set in IP Resolution, this selection
determines method(s) that the PrintServer
will receive the IP Address from the server.

41