ZyXEL Communications 2WE 2.3LED Descriptions, SYS, WLAN, Table 2-1LED Descriptions, Figure 2-2ZyWALL 2 Front Panel

ZyWALL 2 and ZyWALL 2WE

Figure 2-2 ZyWALL 2 Front Panel

2.3LED Descriptions

The following table describes the LED functions. The SYS and WLAN LEDs apply to the ZyWALL 2WE.

		Table 2-1 LED Descriptions
LED	STATUS	LED DESCRIPTION
PWR	Green Light on	The ZyWALL is on and receiving power.
	Light flashing	The ZyWALL is performing a self-test.
	Green Light off	The ZyWALL is not receiving power.
SYS	Green Light on	The ZyWALL is ready.
	Light flashing	The ZyWALL is performing a self-test.
	Red Light on	The ZyWALL is experiencing low voltage.
LAN	Green light	The ZyWALL has a LAN connection of 10Mbps.
10/100M	Orange light	The ZyWALL has a LAN connection of 100Mbps.
1-4	Both lights off	The ZyWALL does not have an Ethernet connection.
	Light flashing	The ZyWALL is sending/receiving packets.
WAN	Green light	The WAN link is connected at 10Mbps.
	Orange light	The WAN link is connected at 100Mbps.
	Light off	The WAN link is not ready, or has failed.
	Light flashing	The WAN link is sending/receiving packets.
CON/AUX	Green light	The CON/AUX switch is set to CON, the CON/AUX port is connected to a
	Orange light	management computer and someone is logged into the ZyWALL.
		The CON/AUX switch is set to AUX and the CON/AUX port has an Internet
		connection through a dial-up modem.
	Light off	The CON/AUX link is not ready, or has failed.
	Light flashing	The CON/AUX switch is set to AUX and the CON/AUX port is sending or
		receiving data through a dial-up modem or ISDN TA.
WLAN	Light on	The Wireless LAN feature is enabled.
	Light off	The Wireless LAN link is not ready, or has failed.
	Light flashing	The Wireless LAN link is sending/receiving packets.

2-2 Hardware Installation