Prestige 310 Broadband Sharing Gateway

Menu 11.3 - Remote Node Network Layer Options

IP Address Assignment= Dynamic

IP Address= N/A

IP Subnet Mask= N/A

Gateway IP Addr= N/A

Network Address Translation= SUA Only

Metric= N/A

Private= N/A

RIP Direction= None

Version= N/A

Multicast= None

Enter here to CONFIRM or ESC to CANCEL:

Press Space Bar to Toggle.

Figure 6-4 Menu 11.3 — Applying NAT to the Remote Node

The following table describes the options for Network Address Translation.

Table 6-3 Applying NAT in Menus 4 and 11.3

FIELD

OPTIONS

DESCRIPTION

Network

Full

When you select this option the SMT will use Address Mapping Set 1

Address

Feature

(menu 15.1 - see section 6.3.1 for further discussion). You can configure

Translation

 

any of the mapping types described in Table 6-2. Choose Full Feature if

 

 

you have multiple public WAN IP addresses for your Prestige.

 

 

 

 

None

NAT is disabled when you select this option.

 

 

 

 

SUA Only

When you select this option the SMT will use Address Mapping Set 255

 

 

(menu 15.1 - see section 6.3.1). Choose SUA Only if you have just one

 

 

public WAN IP address for your Prestige.

6.3NAT Setup

Use the Address Mapping Sets menus and submenus to create the mapping table used to assign global addresses to computers on the LAN. You can see two NAT Address Mapping sets in menu 15.1. You can only configure Set 1. Set 255 is used for SUA. When you select Full Feature in menu 4 or 11.3, the SMT will use Set 1, which supports all mapping types as outlined in Table 6-2.When you select SUA Only, the SMT will use the pre-configured Set 255 (read only).

Network Address Translation (NAT)

6-7