Prestige 662H/HW Series User’s Guide

CHAPTER 31

Remote Node Configuration

This chapter covers remote node configuration.

31.1 Remote Node Setup Overview

This section describes the protocol-independent parameters for a remote node. A remote node is required for placing calls to a remote gateway. A remote node represents both the remote gateway and the network behind it across a WAN connection. When you use menu 4 to set up Internet access, you are configuring one of the remote nodes.

You first choose a remote node in Menu 11- Remote Node Setup. You can then edit that node’s profile in menu 11.1, as well as configure specific settings in three submenus: edit IP and bridge options in menu 11.3; edit ATM options in menu 11.6; and edit filter sets in menu 11.5.

31.2Remote Node Setup

This section describes the protocol-independent parameters for a remote node.

31.2.1Remote Node Profile

To configure a remote node, follow these steps:

1From the main menu, enter 11 to display Menu 11 - Remote Node Setup.

2When menu 11 appears, as shown in the following figure, type the number of the remote node that you want to configure.

Chapter 31 Remote Node Configuration

326