ZyXEL Communications 662H Series, 662HW Series 40.2.2 Using the FTP Command from the Command Line, 40.2.3Example of FTP Commands from the Command Line

Prestige 662H/HW Series User’s Guide

Figure 239 Telnet in Menu 24.5

Menu 24.5 - System Maintenance - Backup Configuration

To transfer the configuration file to your workstation, follow the procedure below:

1.Launch the FTP client on your workstation.

2.Type "open" and the IP address of your Prestige. Then type "root" and SMT password as requested.

3.Locate the 'rom-0' file.

4.Type 'get rom-0' to back up the current Prestige configuration to

your workstation.

For details on FTP commands, please consult the documentation of your FTP client program. For details on backup using TFTP (note that you must remain in this menu to back up using TFTP), please see your Prestige manual.

Press ENTER to Exit:

40.2.2 Using the FTP Command from the Command Line

1Launch the FTP client on your computer.

2Enter “open”, followed by a space and the IP address of your Prestige.

3Press [ENTER] when prompted for a username.

4Enter your password as requested (the default is “1234”).

5Enter “bin” to set transfer mode to binary.

6Use “get” to transfer files from the Prestige to the computer, for example, “get rom-0 config.rom” transfers the configuration file on the Prestige to your computer and renames it “config.rom”. See earlier in this chapter for more information on filename conventions.

7Enter “quit” to exit the ftp prompt.

40.2.3Example of FTP Commands from the Command Line

Chapter 40 Firmware and Configuration File Maintenance 398