Dimension
10.2 Activating Spanning Tree Protocol
Use the Switch Configuration screen to activate STP on the switch.
Step 1. Click Administrator, Switch Configuration and then the Advanced tab. Step 2. Select the Enable STP Protocol check box under Protocol Enable Settings:.
FigureStep 3. Click Apply to save the changes.
10.3 Configuring Spanning Tree Parameters
To configure STP on the switch, click Administrator and then Spanning Tree.
FigureThe following table describes the related fields to configure on a global basis (for the entire switch).
TableFIELD | DESCRIPTION | EXAMPLE |
|
|
|
Priority | To set the priority of this switch in a spanning tree, enter a | 32768 |
| number between 1 and 65535. |
|
| A higher value indicates a lower priority; thus 0 means the |
|
| highest priority. The default is 32768. |
|
Spanning Tree Protocol |