Dimension
Chapter 13
Introducing the SMT
This chapter introduces the basics of managing the switch.
13.1 Introduction
The System Management Terminal (SMT) is a menu – driven interface that you use to configure the switch. You may access the SMT using either Telnet or the console port.
If there is no activity for longer than 5 minutes after you log in,
your switch will automatically log you out.
13.2 Accessing the SMT Using Telnet
Follow the steps below to access the SMT screens using a Telnet program. Step 1. Launch a Telnet program. In Windows, click Start and then Run.
Step 2. Type “telnet” followed by a space and the IP address of the switch, (192.168.1.1 is the default) and then click OK to display the password screen. Refer to Figure
Figure 13-1 Starting a Telnet Session
13.3 Accessing the SMT Using the Console Port
The console configuration is for local management and initial configuration of the switch.
Use an
Introducing the SMT |