ZyXEL Communications P-2302HWUDL-P1 Series 95

Chapter 5 Wireless LAN

The following table describes the labels in this screen.

Table 40 Network > Wireless LAN > OTIST

LABEL	DESCRIPTION
Setup Key	Type a key (password) 8 ASCII characters long.

	Note: If you change the OTIST setup key in the ZyXEL
	Device, you must change it on the wireless devices
	too.

Yes!	Select this if you want the ZyXEL Device to automatically generate a pre-
	shared key for the wireless network. Before you do this, click Network >
	Wireless LAN > General and set the Security Mode to No Security.
	Clear this if you want the ZyXEL Device to use a pre-shared key that you
	enter. Before you do this, click Network > Wireless LAN > General, set the
	Security Mode to WPA-PSK, and enter the Pre-Shared Key.
Start	Click Start to activate OTIST and transfer settings. The process takes three
	minutes to complete.
	Note: You must click Start in the ZyXEL Device and in the
	wireless device(s) within three minutes of each other.
	You can start OTIST in the wireless devices and the
	ZyXEL Device in any order.

Before you click Start, you should enable OTIST on all the OTIST-enabled devices in the wireless network. For most devices, follow these steps.

1Start the ZyXEL utility

2Click the Adapter tab.

3Select the OTIST check box, and enter the same Setup Key as the ZyXEL Device.

4Click Save.

Figure 49 Example: Wireless Client OTIST Screen

To start OTIST in the device, click Start in this screen.