P312 Broadband Security Gateway

Chapter 4

Remote Node Setup

This chapter shows you how to configure a remote node. A remote node is required for placing calls to a remote gateway. A remote node represents both the remote gateway and the network behind it across a WAN connection. Note that when you use Menu 4 to set up Internet access, you are actually configuring a remote node. We will show you how to configure Menu 11.1 Remote Node Profile, Menu 11.3 - Remote Node Network Layer Options and Menu 11.5 - Remote Node Filter.

4.1Remote Node Profile

From the Main Menu, select menu option 11 to open Menu 11.1 - Remote Node Profile. There are two variations of this menu depending on whether you choose Ethernet Encapsulation or PPPoE

Encapsulation.

4.1.1 Ethernet Encapsulation

You must choose the Ethernet option when the WAN port is used as a regular Ethernet. The first Menu 11.1 screen you see is for Ethernet Encapsulation shown next.

Menu 11.1 - Remote Node Profile

Rem Node Name= ChangeMe

Route= IP

Active= Yes

 

Encapsulation= Ethernet

Edit IP= No

Service Type= Standard

Session Options:

Service Name= N/A

Edit Filter Sets= No

Outgoing=

 

My Login= N/A

 

My Password= N/A

 

Server IP= N/A

 

Press ENTER to Confirm or ESC to Cancel:

Figure 4-1 Menu 11.1 Remote Node Profile for Ethernet Encapsulation

Remote Node Setup

4-1

Page 60
Image 60
ZyXEL Communications P-312 manual Remote Node Setup, Remote Node Profile