ZyXEL Communications P-324 9.5.2 Traffic Redirect Setup, Table 9-6Traffic Redirect Setup, using Menu 11.6 — Traffic Redirect Setup, Figure 9-10Menu 11.6 — Traffic Redirect Setup

Prestige 324 Intelligent Broadband Sharing Gateway

9.5.2 Traffic Redirect Setup

Configure parameters that determine when the Prestige will forward WAN traffic to the backup gateway

using Menu 11.6 — Traffic Redirect Setup.

Menu 11.6 - Traffic Redirect Setup

Active= Yes

Configuration:

Backup Gateway IP Address= 0.0.0.0

Metric= 15

Check WAN IP Address= 0.0.0.0

Fail Tolerance= 2

Period (sec)= 5

Timeout (sec)= 3

Press ENTER to Confirm or ESC to Cancel:

Press Space Bar to Toggle.

Figure 9-10 Menu 11.6 — Traffic Redirect SetupTable 9-6 Traffic Redirect Setup

FIELD	DESCRIPTION	EXAMPLE
Active	Press [SPACE BAR] and select Yes (to enable) or No (to disable) traffic	Yes
	redirect setup. The default is No.
	When the Active field is Yes, you must configure every field in this screen
	unless you are using PPPoE or PPTP encapsulation (except Check WAN
	IP Address and Timeout).
	If you don’t configure these fields and are using PPTP or PPPoE
	encapsulation, then the Prestige checks the PPPoE channel or PPTP
	tunnel to determine if the WAN connection is down.
Configuration:
Backup	Enter the IP address of your backup gateway in dotted decimal notation.	0.0.0.0
Gateway IP	The Prestige automatically forwards traffic to this IP address if the
Address
	Prestige’s Internet connection terminates.
Metric	Enter a number from 1 to 15 to set this route’s priority among the	15
	Prestige’s routes (see Route Priority and Metric on page 9-11) The	(default)
	smaller the number, the higher priority the route has.

Remote Node Setup 9-13