ZyXEL Communications P-324 13.5 Applying a Filter and Factory Defaults, 13.5.1 LAN traffic, Figure 13-14Filtering LAN Traffic, Figure 13-13Protocol and Device Filter Sets

Prestige 324 Intelligent Broadband Sharing Gateway

Figure 13-13 Protocol and Device Filter Sets

13.5 Applying a Filter and Factory Defaults

This section shows you where to apply the filter(s) after you design it (them).

13.5.1 LAN traffic

You seldom need to filter LAN traffic; however, the filter sets may be useful to block certain packets, reduce traffic and prevent security breaches. Go to menu 3.1 (shown below) and enter the number(s) of the filter set(s) that you want to apply as appropriate. You can choose up to four filter sets (from twelve) by entering their numbers separated by commas, e.g., 3, 4, 6, 11. Input filter sets filter incoming traffic to the Prestige and Output filter sets filter outgoing traffic from the Prestige.

Menu 3.1 – LAN Port Filter Setup

Input Filter Sets: protocol filters= device filters= Output Filter Sets: Protocol filters= device filters=

Press ENTER to Confirm or ESC to Cancel:

Apply

factory

default

filter

here.

Figure 13-14 Filtering LAN Traffic

Filter Configuration 13-17