ZyXEL Communications P-324 Table 6-3Advanced WAN Port Setup: AT Commands Fields, Table 6-4Advanced WAN Port Setup: Call Control Parameters

Prestige 324 Intelligent Broadband Sharing Gateway

Table 6-3 Advanced WAN Port Setup: AT Commands Fields

FIELD	DESCRIPTION	DEFAULT
AT Response String:
CLID (Calling Line	Enter the keyword that precedes the CLID (Calling Line Identification)	NMBR =
Identification)	in the AT response string. This lets the Prestige capture the CLID in
	the AT response string that comes from the WAN device. CLID is
	required for CLID authentication.
Called Id	Enter the keyword preceding the dialed number.	TO
Speed	Enter the keyword preceding the connection speed.	CONNECT

Table 6-4 Advanced WAN Port Setup: Call Control Parameters

FIELD	DESCRIPTION	DEFAULT
Call Control
Dial Timeout (sec)	Enter a number of seconds for the Prestige to keep trying to set up	60 seconds
	an outgoing call before timing out (stopping). The Prestige times
	out and stops if it cannot set up an outgoing call within the timeout
	value.
Retry Count	Enter a number of times for the Prestige to retry a busy or no-	0 to disable
	answer phone number before blacklisting the number.	the blacklist
		control
Retry Interval	Enter a number of seconds for the Prestige to wait before trying
(sec)	another call after a call has failed. This applies before a phone
	number is blacklisted.
Drop Timeout	Enter a number of seconds for the Prestige to wait before dropping	20 seconds
(sec)	the DTR signal if it does not receive a positive disconnect
	confirmation.
Call Back Delay	Enter a number of seconds for the Prestige to wait between	15 seconds
(sec)	dropping a callback request call and dialing the co-responding
	callback call.

6-6 WAN Setup and Dial Backup