ZyXEL Communications P-324 11.3 NAT Setup, Set, Set, Full Feature, Table 11-3Applying NAT in Menus 4 &, Figure 11-4Menu 11.3 — Applying NAT to the Remote Node

Menu 11.3 - Remote Node Network Layer Options

IP Address Assignment= Dynamic

IP Address: N/A

IP Subnet Mask= N/A

Gateway IP Addr= N/A

Network Address Translation= Full Feature

Metric= 1

Private= No

RIP Direction= None

Version= N/A

Multicast= None

Enter here to CONFIRM or ESC to CANCEL:

Press Space Bar to Toggle.

Figure 11-4 Menu 11.3 — Applying NAT to the Remote NodeThe following table describes the options for Network Address Translation.

		Table 11-3 Applying NAT in Menus 4 & 11.3
FIELD	OPTIONS		DESCRIPTION
Network	Full		When you select this option the SMT will use Address Mapping Set 1
Address	Feature		(menu 15.1 - see section 11.3.1 for further discussion). You can
Translation			configure any of the mapping types described in Table 11-2. Choose
			Full Feature if you have multiple public WAN IP addresses for your
			Prestige.
	None		NAT is disabled when you select this option.
	SUA Only		When you select this option the SMT will use Address Mapping Set 255
			(menu 15.1 - see section 11.3.1). Choose SUA Only if you have just one
			public WAN IP address for your Prestige.

11.3 NAT Setup

Use the Address Mapping Sets menus and submenus to create the mapping table used to assign global addresses to computers on the LAN. You can see two NAT Address Mapping sets in menu 15.1. You can only configure Set 1. Set 255 is used for SUA. When you select Full Feature in menu 4 or 11.3, the SMT

11-8 NAT