where “i” specifies binary image transfer mode (use this mode when transferring binary files), “host” is the Prestige IP address, “get” transfers the file source on the Prestige (rom-0 name of the configuration file on the Prestige) to the file destination on the computer and renames it config.rom.

TFTP GUI Clients

The following table describes some of the fields that you may see in some TFTP GUI clients.

 

Table 17-3 General Commands for TFTP GUI Clients

 

 

COMMAND

DESCRIPTION

 

 

Host

Enter the IP address of the Prestige. 192.168.1.1 is the Prestige’s default IP address

 

when shipped.

Send/Fetch

Use “Send” to upload the file to the Prestige and “Fetch” to back up the file on your

 

computer.

 

 

Local File

Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom

 

extension) on your computer.

 

 

Remote File

This is the filename on the Prestige. The filename for the firmware is “ras” and for the

 

configuration file, is “rom-0”.

Binary

Transfer the file in binary mode.

 

 

Abort

Stop transfer of the file.

 

 

Refer to the TFTP and FTP over WAN Will Not Work When section to read about configurations that disallow TFTP and FTP to work over WAN.

17.2.4 Backup Via Console Port

Backup configuration via console port by following the HyperTerminal procedure shown next. Procedures using other serial communications programs should be similar.

Step 13. Display menu 24.5 and enter “y” at the following screen.

17-6

Firmware and Configuration Maintenance